MASTERCAM TOOLHOLDER CLEARANCE OPTIROUGH

Mastercam solid containment boundary

Choose your solid, and select your Containment Boundary. In the Tool Path Parameters, make sure that "Inside" is set for your containment boundary, and it should cut the whole shape in one path.
[Free PDF Download]

FAQS about Mastercam solid containment boundary

How do I set a tool containment within a boundary?

Under the Geometry tab, a Boundary has been added in the “Boundaries and Points” section and the type of tool containment within this boundary is being set to Contact. Notice the options “Tool containment” which lets you control whether the tool is restricted to the inside of the boundary, can move to the center or move outside the boundary.

What does the pocket size setting do in Mastercam?

Specifies a minimum pocket size that Mastercam will create a cutting pass for. This helps with problems where Mastercam thinks that a pocket is large enough to accommodate the tool, but the entry move is so compressed the tool is effectively plunging into the part. 22 Select the Linking Parameters page.

What are boundary options in HSM Performance Pack?

Useful for gaining more control over the toolpath by limiting machining to a confined area within a boundary – and for controlling exactly how close to the boundary a tool is allowed to cut. Boundary options in HSM Performance Pack include Machining, Contact an Stock boundaries which are supported by most of our strategies.

What is the approach distance parameter in Mastercam?

The values entered help Mastercam to calculate the most efficient material removal strategy when machining part walls. The Approach distance parameter allows you to add a specified absolute distance to the beginning of the toolpath’s first cut. Dynamic toolpaths create highly efficient motion based on selected chains and surfaces.

What are the options for a Mastercam?

Options range from a simple helix to a medial path with trochoidal motion to a selected open chain. Mastercam’s Help contains detailed information on each of the methods available. Use Entry feeds and speeds to avoid placing too much load on the tool upon entry.

How do I chain a stock in Mastercam?

You can also use the Silhouette Boundary function and then chain your stock. What version of Mastercam are you using? You can pick a solid model for stock in Stock Setup, but if you want to use it to control toolpaths you should create a Stock Model from the solid. Then you can specify that stock model in your dynamic paths. Using X7.